Full 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the truck arrives.
Before
After
Before
After
Before
AfterFast, Reliable Garage Door Installation Across Englewood
Garage door installation in Englewood typically runs $700-$2,200 for a new door, with most standard single-car replacements landing in the $900-$1,400 range and custom wood or carriage-house builds reaching the upper end. If you live in one of Englewood’s postwar ranch homes near South Broadway or a bungalow off Hampden, you already know the catch: your garage was likely framed in the 1950s with clearances that make a straightforward sectional swap anything but straightforward. We know because we’re the company that shows up with the right hardware the first time. Call (720) 636-7083 and we’ll give you a written price with the exact scope before any work starts. That’s not a courtesy. That’s Clause 1 of The Haven Standard.
Why Servo Garage Doors Littleton Is Englewood’s Preferred Garage Door Installation Company
Here’s what separates us from the second-trip crews: we photograph the existing opening before we quote, and we measure headroom, track angle, and door weight on site, in writing. Englewood homes along South Ogden, South Sherman, and the blocks north of Belleview force a specific kind of retrofit work, and we’ve done enough of it to stock the low-headroom bracket kits, jackshaft openers, and custom track angles those garages require. Marcus Deller, who leads our Englewood work, has converted enough 1950s tilt-up doors to sectional systems to tell you within an inch whether your existing header will clear a standard 12-inch radius track. The answer in much of old Englewood is no. We plan for it from the first visit.
We’re an Garage Door Installation company that treats documentation the way other contractors treat sales talk. Every job gets a flat, written price and a written scope before any work begins. Every visit closes with a photo record of what we found and what we did. Our 365-Day Done Right Promise means what it says: if it’s not right, we make it right, backed by a terms page, not a handshake.
Englewood homeowners get background-checked, uniformed technicians on every job, with the license number on the page, not buried in fine print. And when you call at 6 a.m. because your door won’t open and your car is trapped inside a detached garage on a narrow city lot, a live person answers. We also offer Garage Door Repair in Englewood for those urgent morning breakdowns. That’s 24/7 coverage, including holidays, and you get a named technician and an on-the-way text.
Our Garage Door Installation Services in Englewood
New Door Installation
A new door in Englewood means working with what the original builder left you, which is often a 7-foot opening with a header framed tight to the roofline. We carry Clopay, Amarr, and Wayne Dalton doors and we plan the install around your actual clearance. Most standard replacements in Englewood land between $700 and $2,200, depending on the door, the insulation spec, and the retrofit hardware. You’ll see the written scope and price before we order anything.
Single Car Door
The single-car garage is the default in Englewood’s 1940s-1960s housing stock, whether it’s attached to a ranch on a quarter-acre lot or a detached structure accessed from the alley behind South Broadway. These openings are frequently out of square by half an inch or more. We cut and shim track assemblies on-site, so the door runs true instead of binding after three cycles. If your single door is a wooden tilt-up panel from the Eisenhower administration, we’ll give you a straight answer on repair versus replacement, with the price attached to each option in writing.
Double Car Door
Double doors show up in Englewood’s newer infill construction near the RTD station and in the occasional 1970s split-level. These installs are more forgiving on headroom but heavier on spring math. A 16-foot door needs a torsion spring configured to the door’s exact weight, not a guess. We balance every spring on-site and set the opener’s force and limit switches to the door after the install is complete. Opener installation on an Englewood double door runs $250-$550 when paired with a new door, and we’ll quote the opener as a separate line item so you see exactly what you’re paying for.
Custom Garage Door
Custom work in Englewood means wood doors, carriage-house designs, and openers that integrate with your home’s smart systems. We’ve built and installed custom doors for bungalows along the tree-lined blocks west of Clarkson and for the larger lots near Bates-Logan Park. A custom door costs more because the design work, the material, and the hardware are all spec-matched to your opening. You’ll get the drawings, the door weight, the spring spec, and the opener compatibility all in writing before the first component is ordered.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Before
AfterTrusted Brands We Service in Englewood
We install and service all eight major brands: LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor. For Englewood specifically, we keep Genie openers and Clopay carriage-house sections moving through our local parts inventory because they’re what this city’s older homes call for most often. The jackshaft opener situation is real: many Englewood garages have ceilings too low or too cluttered for a traditional center-mount opener, and the LiftMaster 8500 or Genie counterpart is the correct fix. We stock the low-headroom bracket kits and the jackshaft mount plates so we’re not sending a truck back to the supplier mid-job.
Common Garage Door Installation Problems We See in Englewood Homes
- Tight headroom above the opening. Englewood’s 1940s-1960s ranch and bungalow garages often have only 1-2 inches above the header, not the 12+ inches a standard sectional door’s track radius requires. The fix is a low-headroom bracket kit and a custom track angle, installed on-site against your actual framing measurements.
- Out-of-square openings on detached garages. Backyard garages on narrow Englewood city lots have settled over 60 years, and the opening often isn’t square. Pre-fabricated track assemblies bind; we cut and adjust the vertical tracks so the door travels without catching.
- Chinook-wind stress on doors and seals. Englewood sits at 5,300 feet, and a 50-degree temperature swing in one day does things to steel doors and rubber seals. Panels expand, seams pop, and bottom seals tear within a season unless the door was specified with insulation rated for high-altitude thermal cycling.
- Freezing doors on winter mornings. The seal at the bottom of the door freezes to the concrete driveway, and the opener strains or the panel bends when the door is forced. We see this in Englewood every winter, mostly on older doors with hardened seals. The fix is a new seal matched to the door and the climate, plus opener force settings corrected for the cold.
Pricing for Garage Door Installation in Englewood, CO
Here’s what we tell Englewood homeowners before we quote anything: the price is written, the scope is written, and both are delivered before any work starts. No exceptions. That’s Clause 1 of The Haven Standard, and it means the number you approve is the number on the invoice.
| Service | Englewood Price Range |
|---|---|
| New Door Installation | $700-$2,200 |
| Track Realignment | $120-$240 |
| Opener Installation | $250-$550 |
Your installed cost depends on door type, insulation spec, hardware requirements, and whether we’re retrofitting a 1950s opening for low-headroom operation. A single-car steel door on a ranch near Hampden will run the low end; a custom wood carriage-house door on a bungalow near Bates-Logan Park will run the high end. The quote is free and it’s binding. Call (720) 636-7083 for a written estimate.
Englewood’s residential core is dominated by postwar ranch homes and bungalows built between 1940 and 1970. The detached single-car garages on those lots were framed for tilt-up doors, not modern sectional systems. If you’re on South Broadway north of Belleview, there’s a good chance your garage has one to two inches of clearance above the opening. That means a standard sectional conversion won’t fit without specific hardware. We bring that hardware on the first trip because we plan for Englewood’s stock, not for a generic 2010 suburban tract.
Here’s how it works in practice. Just last week, our techs converted a 1958 ranch on South Ogden Street from a single-panel tilt-up to a Clopay carriage-house sectional with a LiftMaster 8500 jackshaft opener. The original header left barely two inches, so we installed low-headroom brackets, reset the track alignment to a custom 12-degree angle, and balanced the new torsion spring to the door’s exact weight. The homeowner now has a whisper-quiet, smart-home-integrated door that clears the ceiling cleanly. That’s the kind of work this city’s garages need, and it’s the work we do every week across Englewood.
We Also Serve Cities Near Englewood
Our Englewood crews also cover Garage Door Installation in Englewood‘s neighboring communities: Littleton, Lone Tree, Denver, and Aurora. If you’re on the edge of Englewood’s city limits or just over the line, we’ll still quote you a written price and show up with the right parts for your garage’s clearance, age, and door type.
Serving Englewood, CO - Our Local Coverage Area
We’re based in the Englewood area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Garage Door Installation in Englewood
No, not without a low-headroom bracket kit and a custom track angle. Standard sectional doors need roughly 12 inches of headroom for the curved track section; Englewood’s postwar garages often have 1-2. We install the low-headroom kit, reset the track to the correct angle for your opening, and balance the spring to the door’s weight. The price range for the full conversion is the same $700-$2,200 as a standard install because the hardware is part of the written scope. Call (720) 636-7083 for a quote that reflects your actual header clearance.
If the door is a 1950s or 1960s solid-wood tilt-up panel, replacement is almost always the better call. Warped wooden panels don’t seal, they bind in the track, and they fight the opener motor. A new sectional door in Englewood runs $700-$2,200 installed, and we can build it as a wood-look or true wood carriage door that matches your bungalow’s character. We’ll give you repair and replacement options in writing, with prices, so you don’t have to guess.
The bottom seal freezes to the concrete because Englewood’s chinook-driven temperature drops push surface temperatures below freezing quickly, and a rubber seal with poor thermal resilience bonds to the cold slab. The fix is a high-quality neoprene or EPDM seal matched to the door’s thickness and the climate, plus opener force settings adjusted for cold weather so the motor doesn’t strain. We replace seals and correct opener settings on Englewood doors all winter; call (720) 636-7083 and we’ll bring the right seal to your door the first trip.
You want a torsion spring rated for at least 10,000 cycles, and you want it balanced to the door’s exact weight. Englewood’s high-altitude sun and chinook temperature swings fatigue springs faster than a stable coastal climate does, so a cheap 5,000-cycle spring can fail within three to four years. We install springs rated for 10,000+ cycles and document the balance test in your photo record. A spring replacement runs $180-$340, and the quote is fixed before we touch the door.
Most likely yes. Custom wood doors are heavy, often exceeding 150 pounds, and many Englewood bungalows have low or finished ceilings that rule out a standard center-mount opener. The correct solution is often a jackshaft opener, like the LiftMaster 8500, mounted to the wall beside the door. It handles weight better and clears a low or cluttered ceiling. Opener installation in Englewood runs $250-$550, and we’ll spec the opener to your door’s weight in the written quote. Call (720) 636-7083 and we’ll tell you which opener your door needs, with the price on paper.
Written by Marcus Deller, Owner at Servo Garage Doors Littleton, operating under The Haven Standard for Englewood and the surrounding Front Range communities.
Need a written price on a door that’s measured for your actual garage? Call (720) 636-7083 today. We’ll document the opening, the clearance, and the scope, then hand you a number that won’t move. That’s how Servo does it in Englewood.