Full 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the truck arrives.
Before
After
Before
After
Before
AfterFast, Reliable Garage Door Installation Across Evergreen
A new garage door in Evergreen, CO typically runs between $700 and $2,200 installed, depending on material, size, and whether we’re retrofitting an older opening or working with fresh framing. Most replacements take one day once the door is on hand. If you’re calling from Evergreen, you’ll reach a live person at (720) 636-7083, not a menu tree.
We know the drive up Highway 74, we know the switchbacks off Squaw Pass Road, and we know what a 1972 tuck-under garage looks like because we’ve worked on dozens of them. Evergreen isn’t a suburb with uniform lot grading. It’s mountain terrain with legacy construction, and that changes how a door gets installed.
Why Servo Garage Doors Littleton Is Evergreen’s Preferred Garage Door Installation Company
We’re an independently owned and operated company under The Haven Standard, led by Marcus Deller. That means every Evergreen job gets a flat, written price and a written scope of work before any tool leaves the truck. Clause 1 of The Haven Standard says it plainly: no verbal estimates, no ‘call for a quote’ ambiguity. You see the number on paper first.
What builds trust in Evergreen isn’t a tagline. It’s the photo record. Clause 4 of The Haven Standard requires our technicians to photograph the failed component before quoting a replacement, and to deliver that documentation to you when the job closes. If we say a torsion spring measured at 0.225-inch wire diameter and snapped clean at the coil, you’ll have the picture to prove it. That’s the paper trail Marcus built the company on in 2015, now applied to more than 18,000 garage doors made right.
Our technicians are background-checked and uniformed. Every one of them carries parts for the common Evergreen failures: extension springs for legacy one-piece doors, side-mount opener kits for tight tuck-under headrooms, and full-contact bottom seals sized for uneven mountain slabs.
Our Garage Door Installation Services in Evergreen
All installation work starts with a measure, a written quote, and a conversation about what’s actually on your wall. Here’s what we install most in Evergreen:
New Door Installation
A full replacement in Evergreen runs $700-$2,200. That includes removal of the old door, haul-away, track and hardware, springs, and a full-contact weather seal at the bottom and sides. On older Evergreen homes where the original opening was framed for a one-piece tilt-up door, we often need to add an intermediate header bracket or adjust the track radius to fit a modern sectional. That’s part of the scope, and it’s on the written estimate before we start.
Single Car Door
Most single-car garages in Evergreen are from the 1960s and 1970s and measure 9 feet wide by 7 feet tall, though some A-frame cabins have non-standard 8-foot-wide openings. We quote by actual measurement, not by assumption. A single steel door with basic insulation typically lands between $700 and $1,400 installed, depending on what the framing and slab allow.
Double Car Door
Double doors on Evergreen’s hillside homes often span 16 feet across a tuck-under opening where the slab has settled unevenly. That means the left track and right track may need independent shimming to keep the door level through its full travel. A double door installation here usually runs $1,200-$2,200, with heavier-gauge steel and better insulation pushing toward the upper end.
Custom Garage Door
Custom work in Evergreen means matching door proportions to openings that were never standard. We’ve built openings to fit 7-foot-6-inch headers on a 1990s hillside home off Kerr Gulch Road, and we’ve sourced custom-height Amarr doors for garages where the original builder cut corners on framing. Custom doors start around $1,800 and go up based on material, window inserts, and track configuration. The written price includes everything, including the design consultation.
Steel Doors
For Evergreen specifically, steel makes structural sense. It doesn’t swell or bind the way wood does when the humidity locks in after a spring snowmelt. A well-built steel door from Clopay or Amarr with an insulated core will take the overnight temperature swings at 7,000 feet without warping. We recommend steel for most Evergreen homes, and we’ll tell you when wood makes more sense for the architecture.
Wood Doors
Wood doors belong on Evergreen’s older mountain homes: the A-frames, the log-sided cabins, the houses where a steel door would read as a replacement, not an improvement. Wood requires maintenance here. The altitude dries it out, the snowpack holds moisture against the bottom panel, and swelling is a real failure mode. We install wood doors with extra clearance at the jambs and a more aggressive bottom seal profile to handle the freeze-thaw cycle.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Before
AfterTrusted Brands We Service in Evergreen
We install and service Clopay, Amarr, Chamberlain, and Genie among others. We keep common Evergreen failure parts on the truck: extension spring sets for legacy doors, side-mount opener brackets, and photo-eye sensor kits rated for cold operation. If your current door is a Wayne Dalton or a Raynor, we work on those too. The brand matters less than the opening geometry, and in Evergreen the opening geometry is almost always the harder variable.
Common Garage Door Installation Problems We See in Evergreen Homes
- Legacy one-piece doors coming to the end of service life. A 1968 tilt-up door with original extension springs is a single failed spring away from dropping onto whatever is under it. Evergreen’s freeze-thaw cycle has been stressing those springs for 50 years. When one lets go, the door doesn’t fail gracefully.
- Track alignment drift from soil movement. Evergreen’s sloped lots shift with freeze-thaw cycles. A tuck-under garage slab that moved 1.5 inches over 40 years will pull the tracks out of parallel, and the door will jump the drums and jam halfway. Retrofit work is common, and it’s why we shim and plate rather than bolting new tracks onto a crooked wall.
- Auto-close sensors calibrated for flat ground. Sensors aimed for a flat Denver driveway often fail on Evergreen’s sloped approaches. The beam misses the reflector, the door reverses, and the owner walks away with the door six inches off the ground. In bear country, that gap is a wildlife conflict waiting to happen.
- Wood doors that swell and bind at elevation. Roughly 80 to 100 inches of annual snowfall means water sits against the bottom of a wood door for weeks. The panels absorb it, swell, and the door starts binding in the tracks. Evergreen’s diurnal temperature swings make this a near-annual maintenance cycle on wood doors that aren’t sealed properly.
Pricing for Garage Door Installation in Evergreen, CO
Here’s what you’ll see on a written estimate for work in Evergreen:
| Service | Typical Price Range in Evergreen |
|---|---|
| New Door Installation | $700 - $2,200 |
| Spring Repair | $180 - $340 |
| Track Realignment | $120 - $240 |
| Cable Repair | $130 - $250 |
What moves the number is the opening itself: headroom on a tuck-under garage, whether the slab is level, what the framing looks like behind the old track mounts. You’ll get a flat price and written scope before we start, per Clause 1 of The Haven Standard. Estimates are free. If you have a written estimate from another company, bring it in and we’ll give you a Free Second Opinion on it.
We Also Serve Cities Near Evergreen
Our crews run the Highway 74 corridor and the surrounding foothills. In addition to Evergreen, we install doors in Littleton, Englewood, Golden, and Lone Tree. If you’re in one of those cities and need Garage Door Installation, the same written-price system applies.
Serving Evergreen, CO - Our Local Coverage Area
We’re based in the Evergreen area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Garage Door Installation in Evergreen
Torsion springs fail faster in Evergreen because of the combination of roughly 7,000 feet of elevation and 40-to-50-degree temperature swings in a single 24-hour period during fall and spring. The repeated metal contraction fatigues the spring wire well below the cycle ratings manufacturers publish for lower, warmer elevations. A spring rated for 10,000 cycles in Denver may last half that in Evergreen. We see call volume spike after every hard cold snap. Call (720) 636-7083 if a spring has already gone, and we’ll send a technician with the right wire gauge for altitude conditions.
Most one-piece tilt-up doors in Evergreen can be retrofitted if the door itself is still sound, but many aren’t worth saving once the extension springs have aged out. A retrofit typically means replacing the spring system, adding a side-mount opener, and reworking the bottom weather seal, which runs $180-$340 for springs plus $250-$550 for the opener. If the wood panels are cracked or the hinges are pulling out, a full replacement at $700-$2,200 is the better use of money. We’ll photograph the failed parts and show you before quoting anything.
A bear-resistant garage door in Evergreen has three things: a full-contact bottom seal that meets the slab along its entire width, auto-close photo-eye sensors verified to close the door completely on your specific driveway slope, and close-limit settings checked so the door doesn’t drift open after operation. We test each one with a weighted sled to simulate a bear pushing against the bottom panel, and we document the test with photos. If your door drifts open or leaves a gap, you don’t have a garage door problem in Evergreen. You have a bear problem.
The difference is access and geometry. A tuck-under garage on a hillside lot often has less headroom above the door, which means standard torsion spring setups don’t always fit and a side-mount opener is sometimes the only option. The slab may have settled, which means the spring tension has to compensate for track alignment drift. A flat Denver garage is usually a straight swap; an Evergreen tuck-under is a puzzle. That’s why the written price for spring work here is still $180-$340, but the scope sometimes includes shimming and track correction that flat-land garages never need.
For most Evergreen homes, a steel door from Clopay or Amarr is the lower-maintenance choice: it won’t swell from snowmelt, it won’t warp from the altitude’s dry winter air, and it holds insulation better for a garage that may sit below living space. Wood is the right call for older cabin architecture where the look matters, but expect to reseal it more often and to pay more for a custom-height door. We’ll give you a straight recommendation based on your opening, not a commission on the material.
Call Servo Garage Doors Littleton for Garage Door Installation in Evergreen
If you’re in Evergreen and your garage door needs replacement, a retrofit, or an honest assessment, call (720) 636-7083. You’ll talk to a live person. You’ll get a written price before any work begins. And when the job is done, you’ll have a documented photo record of everything we found and everything we did. That’s how we work, in Evergreen and everywhere else.
Written by Marcus Deller, Owner at Servo Garage Doors Littleton.
Garage Door Installation in Nearby Areas
